Page 1 of 1

$12P Boost multiplier Vs MAP help

Posted: Mon Aug 26, 2013 3:42 pm
by Charlescrown
Just need to know if I need to change any settings in the boost MAP multiplier table? I have the settings for 3 bar boost and notice the kPa scale is as it should be but I don't quiet understand the % scale. It's the same if it were 2 bar. I know its to increase fuel relative to the boost VE table but will it lean out if left the way it is? I don't want to have leaning out problems like I have in the past when under boost.

Re: $12P Boost multiplier Vs MAP help

Posted: Mon Aug 26, 2013 4:10 pm
by Holden202T
you shouldn't need to touch it, only the 20-100kpa ve table and then boost ve table, the rest works itself out. VL400 has set it all up so it does all the hard work for you.

read the advanced tuning guide on how to setup your tune for boost, thats all you need to do to get it running then fine tune ve tables from there to get fueling spot on.

Re: $12P Boost multiplier Vs MAP help

Posted: Mon Aug 26, 2013 4:30 pm
by antus
also need to put something in "Charge Temp - Boost % Coolant contribution for calculating charge temp Vs RPM & MAP"

Re: $12P Boost multiplier Vs MAP help

Posted: Mon Aug 26, 2013 7:59 pm
by Jayme
yeah ive done a 3 bar turbo tune and never touched that table, just left it and fuelling was perfect just tuning the VE table.

Re: $12P Boost multiplier Vs MAP help

Posted: Mon Aug 26, 2013 10:33 pm
by VL400
The multiplier in 12P is only 0-100%, so for 3 bar you may need a rising rate reg to help offset it (if you dont have a boost referenced regulator that will be most of the problem). Some have had no issues tuning to 20+ PSI using the stock table though so it does depend how you have your fuel system setup.

If you do run out of VE due to no rising rate reg the multiplier table can be adjusted. If your running say 20PSI, make the 20 PSI cell 100% (and all above that too) then set up a straight line (as it is now) of values down to 0% at 100kPa.

In 11P it has 0-200% and may make the same change to 12P if it helps.

Re: $12P Boost multiplier Vs MAP help

Posted: Mon Aug 26, 2013 11:01 pm
by delcowizzid
i run stock fuel regs on those multiplier values they are connected to vacuam and will rise 1:1 with boost

Re: $12P Boost multiplier Vs MAP help

Posted: Tue Aug 27, 2013 3:15 pm
by Charlescrown
Thanks heaps. I wasn't sure if I had to change anything. I am only running 15lb boost but due to spiking I went to a 3 bar map sensor and reset it all to the 3 bar. I did a log this afternoon and it's getting there but still looks like it needs more fuel from around 70%ve up so I have upped the Ve's in both maps so will have another go on Thursday. Gotta work tomorrow. (1 day a week He) I love it.