Page 1 of 2
dead blue light
Posted: Mon Dec 02, 2013 8:46 pm
by Mahse
Hi, just wondering on my ecu I got from here, the blue light on the chipboard has died,
What does this mean, other then car won't run?
Cheers
Re: dead blue light
Posted: Mon Dec 02, 2013 9:16 pm
by VL400
Has the bin_sw jumper been removed? The LED will be off with that removed.
Re: dead blue light
Posted: Mon Dec 02, 2013 9:34 pm
by Mahse
Awesome I'll check that,
Cheers
Re: dead blue light
Posted: Thu Dec 05, 2013 8:55 pm
by Mahse
Hey mate, still dead,
I've managed to get a stock ecu to run in the vehicle and I've tested modified ecu in another vehicle,
Any other test I can try to figure out the issue?
Cheers
Re: dead blue light
Posted: Thu Dec 05, 2013 9:06 pm
by Holden202T
got an LED you can touch on the two terminals to test if its the LED or not ?
Re: dead blue light
Posted: Fri Dec 06, 2013 7:20 am
by Mahse
Thanks I'll try that
Does it need the light to b lit to complete circuit?
Re: dead blue light
Posted: Fri Dec 06, 2013 7:40 am
by Holden202T
i don't believe so, i think its just there to let you know which way the jumper is switched (vl400 will be able to confirm)
Re: dead blue light
Posted: Fri Dec 06, 2013 9:33 am
by antus
Yeah thats correct. there is room for 2 bins on the nvram, the jumper picks if its using the top half or the bottom half, and the light is lit if its the first one I think. maybe vice versa. It should still be working overall either way.
Re: dead blue light
Posted: Fri Dec 06, 2013 9:50 am
by VL400
The LED is purely an indicator so will work without it, however LEDs do not generally die so may be something else causing it. If the NVRAM is not working can send it back and will check it out, just send me a PM.
Re: dead blue light
Posted: Fri Dec 06, 2013 3:45 pm
by Mahse
Top stuff fellas,
Thanks for the help,
I'll have another double check for obvious problem if no luck I will greatly appreciate it if u could check for me vl400
Thanks again