Page 9 of 24
Re: Injector Flow Testing Data
Posted: Tue Sep 02, 2014 8:02 am
by Jayme
ooooooooo looks a lot more technical and complicated than the average flow bench
trying to figure out what all the boxes are for?? top one is the original flow bench controller? middle one I would say scope by the coax leads going in, but there is no display so I give up. bottom one is variable voltage power supply?
Re: Injector Flow Testing Data
Posted: Tue Sep 02, 2014 9:10 am
by The1
top one is a fluke 5 1/2 digit multimeter, middle one is a HP Frequency Generator, bottom one is a manson variable power supply.
I have another HP Freq Gen just not setup atm so i can feed both MAF and VSS in. Jimstim in front of the PSU and i have another cheap freq gen next to jimstim to feed in knock signal and another board to convert crank for cam pulse.
Re: Injector Flow Testing Data
Posted: Tue Sep 02, 2014 11:34 am
by VL400
I also thought it was the kitchen, was wondering how you got that past the boss!
Looks really trick, certainly the most complicated inj flow bench I have seen.
Re: Injector Flow Testing Data
Posted: Tue Sep 02, 2014 12:22 pm
by Holden202T
definitely very professional looking
Re: Injector Flow Testing Data
Posted: Tue Sep 02, 2014 9:35 pm
by The1
test run, holds pressure ok with a set of 42lb injectors, biggest i have atm. B10 is the fuel pressure. Will need to try higher pressure and see how it goes.
Re: Injector Flow Testing Data
Posted: Wed Sep 03, 2014 8:32 am
by immortality
It is a very impressive set up with results to match
Re: Injector Flow Testing Data
Posted: Wed Sep 03, 2014 11:21 am
by vlad01
nice and steady that.
Re: Injector Flow Testing Data
Posted: Wed Sep 03, 2014 12:03 pm
by Jayme
be interesting to see how the pump holds up to the ID1000's
Re: Injector Flow Testing Data
Posted: Wed Sep 03, 2014 12:56 pm
by The1
will be interesting, 044 wont handle them for sure but interesting to see what it can supply.
Re: Injector Flow Testing Data
Posted: Wed Sep 03, 2014 10:06 pm
by Holden202T
Hahaha I maxed an 044 with deka 80's so you'll definitely have issues, maybe you need two 044's like I have now!