pcmhacking.net

ooooooooo looks a lot more technical and complicated than the average flow bench

trying to figure out what all the boxes are for?? top one is the original flow bench controller? middle one I would say scope by the coax leads going in, but there is no display so I give up. bottom one is variable voltage power supply?

top one is a fluke 5 1/2 digit multimeter, middle one is a HP Frequency Generator, bottom one is a manson variable power supply.

I have another HP Freq Gen just not setup atm so i can feed both MAF and VSS in. Jimstim in front of the PSU and i have another cheap freq gen next to jimstim to feed in knock signal and another board to convert crank for cam pulse.

I also thought it was the kitchen, was wondering how you got that past the boss!

Looks really trick, certainly the most complicated inj flow bench I have seen.

definitely very professional looking

test run, holds pressure ok with a set of 42lb injectors, biggest i have atm. B10 is the fuel pressure. Will need to try higher pressure and see how it goes.

It is a very impressive set up with results to match

nice and steady that.

be interesting to see how the pump holds up to the ID1000's

will be interesting, 044 wont handle them for sure but interesting to see what it can supply.

Hahaha I maxed an 044 with deka 80's so you'll definitely have issues, maybe you need two 044's like I have now!