pcmhacking.net

Here's me again with my dumb voice, hope you guys enjoy and get something usefull from it. Arh it's late im off.

[youtube]https://www.youtube.com/watch?v=58svlSl6Duo[/youtube]

Nice one

I thought vlad was volunteering for the next how to vid nice work anyway mate

Dazza92VP wrote:I thought vlad was volunteering for the next how to vid nice work anyway mate

Good video mate


On a side note for those with 11P or 12P you do not need to change the ADX calc, its always left as X/10. There are two scalars you set to match the 0V and 5V AFR points (ie 0V=11AFR and 5V=17AFR if the wideband analog output is setup as discussed in this video), everything else is handled behind the scenes for you.

11P is available to the public now??

I think what he is referring to is that's how its setup in both, when its available that is

question about the spartan WB, they state their output is 10AFR @ 0V and 20AFR @ 5V.

I put in those values in 12P, if the sensor is just running in the open air, should it peg out to 20AFR? cos it pegs out to 18.7AFR.

If I saturate the sensor with propane gas, its drops to min of 10AFR which is what I expect.

put a multi meter on the wideband output... does it get to 5V in open air?

I would suspect a bad earth on wideband maybe and hte ecu is not seeing the full 5v from the wideband.

My 14.7 kit does the same. Cant remember the reading but around that.
Im about to put the narrow band back in so see how if compares. As I have nothing to check my readings in tuner pro against.