pcmhacking.net

currently no spare stock not being used by memcals.

Ok if i cannot get one i will buy the whole unit off you
Thanks again

How do i buy a 27fs010 chip and socket off you?

pm sent

Not trying to hijack the thread, but just wondered if you'd ever thought of making the memcal adapters in a way that made it easier for the less experienced to use,
ie: pin offset & orientation in a way that made it self explanatory regarding memcal orientation.

The few that I've helped in the past, I made the VS/T adaptor with the GQ4x flasher pin count in mind, since I steered them to buying them, & left a notch hanging off the
side of the adapter to suit the notch on the middle right side of the memcals.

Again, not telling anyone how to do their job, i'm by no means qualified to the level of you lot.

Yep Ken quite aware, though as you may note to keep costs down the same PCBs are used as the memcals, memcal adapters I sell very little, perhaps 5-10 sets a year. I do plan to do a set of instructions to help clarify the memcal and adapter use, though you are the first to ask for troubleshooting on the adapters, I had quite a few on the memcals which made me add arrows and instructions on the side of the memcal.

The1 wrote:though you are the first to ask for troubleshooting on the adapters,

I wasn't asking for troubleshooting myself, the last person I sent here bought all the gear he needed off you, (R Monk), I was helping him out by making a self
explanatory adapter & just wondered if you'd ever considered or had been asked about it.

I havnt sorry, also of note pin numbers are marked also on PCB, though that may not make sense to some. I will atleasst for the moment do a pdf instructions up and put it in here

added mounting photos in the FAQ Guide for memcal adapters.
EEPROM Burning Bin Stacking and Verifying Data Guide.pdf

Hi The 1

Just wondering if you are still stocking the memcal to burner adaptor to suit a VT V6 or if not do you know where to source them?

Thanks heaps