Page 1 of 1
closed loop dash light
Posted: Sun Sep 21, 2014 8:07 am
by V8hilux
Hi,
Is there a way to turn a small dash light on whilst ose12p is in closed loop ? If so how.
Thanks.
Re: closed loop dash light
Posted: Tue Sep 23, 2014 9:07 am
by V8hilux
Can it be done via the flex outputs?
Re: closed loop dash light
Posted: Tue Sep 23, 2014 9:35 am
by Holden202T
yeah you should be able to IF closed loop is an option to select for a flex table, if its not then no ....
Re: closed loop dash light
Posted: Tue Sep 23, 2014 11:33 am
by VL400
The flex outputs currently do not support flag or single bit items.
Re: closed loop dash light
Posted: Tue Sep 23, 2014 2:56 pm
by kojab
If you have an engine light wired up just short out the diagnostic enable wire A9 to ground (pins 5 & 6 on OBDII socket) and this will get the the engine light flashing. When you drive with this enabled the engine light will flash slowly while in closed loop mode (14.7:1) and much faster when not in closed loop. You could also set up a relay using the flex tables to pull A9 to ground when ever you liked (over 2000 RPM) which would also solve the 10 degs locked spark timing when RPM is under 2000 revs.
This 2000 RPM setting can also be changed in the 12P calibration.
Dick
Re: closed loop dash light
Posted: Tue Sep 23, 2014 3:05 pm
by V8hilux
That will do the trick. Thanks.