How to convert a 202 to Delco

[Macca97]

started my 808 swap. dizzys all locked, stuck an ecotec throttle body on the manifold with the flange off a vn elbow as a spacer
n13 loom is about to get stripped and routed, and 2 injector plugs added

id post a few photos but since photobucket wont work, and i cant work out how to go straight from my phone or computer

[Holden202T]

sounds like your getting there!

For pictures, when you post a reply (not quick reply) there is an option down the bottom of the window to upload an attachment, select that then choose the file you want and hit add the file...

once all the picture are uploaded your pretty much done, then there will be an option beside each picture that says place inline, if you put the cursor where you want it, then hit place inline it will put it in that spot.

[Macca97]

scrapped the n13 loom, had way to many repairs in it, now have a v6 loom spread across the bench


trial photo

[syntaxterror]

Holden202 Are you running a 36-1 or the 6+1 wheel to run the 0411 setup? I started with your tune to run my 3500 v6 on $12p with a 6+1 wheel when I had it. Would like to start building another one this time on a 0411.

[Holden202T]

i have a 202 running a 36 - 1 wheel and its using VL400's igntion module to do that, then i have run a delco on the stand with a 6 + 1 wheel and the jackaroo DFI module and v6 coils, and yes this is the same configuration i was trying to use with the 0411, but i haven't been able to get it going successfully yet enough to say its a good workable thing.

i am in the process of making a modified dizzy to use as a cam sensor, that might help things but im not sure, i have sort of lost interest and time at the moment, but i would like to see it work if that is at all possible.

[syntaxterror]

Hopefully vl400 does another run of the ignition module's as it would be nice to have 6 coils on the v6.

[syntaxterror]

Hi any progress on running the 202 on the 0411?

[antus]

I think you should be able to do it without the cam sensor and with a distributor using just the low resolution trigger, but you'd need to come up with the base tune from one of the American v6 tunes to get started, as I dont think anyone has created any other base tunes yet. When in low resolution mode you also loose sequential injection. Most people loose interest when they hear they need to keep the distributor, and move to the 6+1 on the Delco 808 as its a common conversion and you can use Holden202Ts base tune as a good starting point.

[Holden202T]

i will re-visit this project one day and see if i can get a better result ... but it could be a long wait!

[heff0018]

If I can find some spare time I would like to experiment with this. It might be while off though. Too many projects.