Page 4 of 5
Re: 202 LJ Torana Conversion
Posted: Mon Aug 27, 2018 12:04 pm
by vlad01
Pretty sure that is the min speed to "stop" using the fan as 55Km/h is fast enough to not need the fan. Below 55 the fan is enabled. So setting to 0 will likely stop the fan from working.
Re: 202 LJ Torana Conversion
Posted: Mon Aug 27, 2018 12:05 pm
by v6bucket
vlad01 wrote:Pretty sure that is the min speed to "stop" using the fan as 55Km/h is fast enough to not need the fan. Below 55 the fan is enabled. So setting to 0 will likely stop the fan from working.
How do I get it to turn the fan on?
Re: 202 LJ Torana Conversion
Posted: Mon Aug 27, 2018 12:25 pm
by Holden202T
the fan temp setting should be all you need! are you using the pin from the ecm as the ground for the fan relay ?
in your dash screen, bottom right there is a high speed fan indicator there that will tell you that the ecm is activating that part of it, if that is the case and its not working it will be somewhere else in the wiring.
Re: 202 LJ Torana Conversion
Posted: Mon Aug 27, 2018 12:39 pm
by vlad01
You can test the fan with the command drop down at the very top right once TP is connected and talking. Choose turn on fan and to turn off there is another called set normal or something like that.
That will allow you to toggle the fan at will. There is a bunch of other useful commands there too.
Re: 202 LJ Torana Conversion
Posted: Mon Aug 27, 2018 12:42 pm
by v6bucket
Holden202T wrote:the fan temp setting should be all you need! are you using the pin from the ecm as the ground for the fan relay ?
in your dash screen, bottom right there is a high speed fan indicator there that will tell you that the ecm is activating that part of it, if that is the case and its not working it will be somewhere else in the wiring.
If that's the case, I had 2 grounds to the relay.
Re: 202 LJ Torana Conversion
Posted: Mon Aug 27, 2018 4:50 pm
by Holden202T
yeah most of the outputs from the ECM are the ground side, except for the fuel pump, its the opposite!
Re: 202 LJ Torana Conversion
Posted: Wed Aug 29, 2018 7:07 am
by v6bucket
Fan now works as it should.
Re: 202 LJ Torana Conversion
Posted: Thu Aug 30, 2018 9:46 am
by ralcool
vlad01 wrote:You can test the fan with the command drop down at the very top right once TP is connected and talking. Choose turn on fan and to turn off there is another called set normal or something like that.
That will allow you to toggle the fan at will. There is a bunch of other useful commands there too.
Where are you seeing this menu in TP? It is a feature in a later build?
Re: 202 LJ Torana Conversion
Posted: Thu Aug 30, 2018 11:23 am
by delcowizzid
Is it not charging volts are low
Re: 202 LJ Torana Conversion
Posted: Fri Aug 31, 2018 7:48 am
by v6bucket
I did notice that the volts appear low, the alternator has a large pulley on to slow it down a bit, it was bending the fan blades at high speed, I think I calculated something close to 20000rpm at 7500 engine rpm. I will investigate, I think the alt. is only a 35 or 40 amp unit, the voltage at the battery is ok, will check the connections that feed the ecu, might have to fit a bigger one.