Re: MadMax 355ci VN Calais
Posted: Sat Jan 21, 2017 9:36 pm
Ok, so I just went back to basics on this and tested all aspects of these flex lookups for these fans and i think I have it sorted.
Resolved via the following:
1. I have issue with my temp sender not being very accurate (10C or so out)
2. My 12P isn't v112 as I thought and is v111 for some reason. (good to know)
3. Loose connector on 30 pin on relay was giving me a bump steer as it was only just connecting (now its DT Plugs so no worries).
Works now
All I have to do now is finish the Deutsch plugs for the wiring harnesses off, tidy up the flex tables so they work when there needed and I am cruising for some tuning!!!
Slowly slowly...
Question for the experts on here:
Have I got this table correct for fan on 92 degrees (roughly) from 0-70KPH then 70KPH fan will turn off?
Resolved via the following:
1. I have issue with my temp sender not being very accurate (10C or so out)
2. My 12P isn't v112 as I thought and is v111 for some reason. (good to know)
3. Loose connector on 30 pin on relay was giving me a bump steer as it was only just connecting (now its DT Plugs so no worries).
Works now
All I have to do now is finish the Deutsch plugs for the wiring harnesses off, tidy up the flex tables so they work when there needed and I am cruising for some tuning!!!
Slowly slowly...
Question for the experts on here:
Have I got this table correct for fan on 92 degrees (roughly) from 0-70KPH then 70KPH fan will turn off?