pcmhacking.net

Hi.
I need "DATA STREAM SPECIFICATION" for ECM 1227808 (160 baud, bin AMXY0662) to make a normal 1227808.adx-file, that there is here in the forum does not work, probably wrong.
I will be very grateful.
I found some information, but not sure that it is correct. (Data taken from menu WinALDL).
Moreover, data is incomplete.
Please be supplemented, if anyone can, please.

It would be well worth your time setting up a bin in 12P with the settings from the AMXY bin.
There's a fully defined XDF and ADX files already. Also you would then get 8192 baud data.

This, of course, it would be great, and if still to get NVRAM...(This dream)
To do this, fasten "delco_808_comms_mod_rs232", I do not have such a possibility.

You dont need the nvram, just the comms mod. And you can home brew the coms mod. Then you are back where you started but much better software and definitions.

Lada ecm on a v6?

antus wrote:You dont need the nvram, just the comms mod. And you can home brew the coms mod. Then you are back where you started but much better software and definitions.

Lada ecm on a v6?

Lada has ECM Bosch.

I have Opel-Multec injection system (this is TBI like Holden Astra LD) installed on the engine Peugeot.This is a hobby for the weekend.

So, if these do not have such professors of tuning the data no one?

Offtop.
I jump O2 sensor readings, is this normal?
And what is the IFR?
log recorded WinALDL.

That data looks correct. I think the 160 baud definition you have is correct but you could also try the definition in this techedge toolhttp://wbo2.com/~techedge.com.au/vehicle/aldl160/aldl_sw.htm

I think the 02 looks like its probably volts so .8 is 800mv is rich and .4 is lean. The car will swing rich to lean in closed loop faster than you can see at 160 baud though.

Thank you, antus!
About jumping O2 sensor readings I understood.

Sample definition file download The link does not work