VS Low BCM Pins 4 and 10
Posted: Fri Oct 09, 2015 9:17 am
G'day
Looking in the factory service manual for the Low series BCM pinouts. Pin 4 and pin 10 on Connector YB134 are not used on a LOW series BCM.
Looking at the BCM PCB , these pins have circuits on the PCB .
What I was thinking, is there any way of testing if pins 4 and 10 they are active ?
The reason I am asking this is , I have a VS Ute with a Hard lid and was going to put remote locks on the hard lid.
I heard with the newer VU-VZ utes . when fitting remote locking for a Hard lid . It can be linked up to a 3rd button on a 3 button remote key head.
My VS Ute came with a 2 button key head. This got me thinking about the VS Calais and Statesman with their remote boot release. Maybe I could hook the hard lid remote locking up to the boot release pin.
Then looking at the VS high series BCM. It has a pin for remote boot release. But the VS low series BCM doesn't have a pin for the boot release
That got me thinking about the Pin 4 and Pin 10 of a LOW series BCM. wishful thinking that Holden omitted this from the service manual.
I wonder if either PIN 4 or 10 give a signal if a 3 button remote is used???
The only way I thought of testing my theory is to Buy a 3 button remote , and get it coded to my car. Then cross my fingers and push the 3rd button on the remote and hope there is a signal produced at pin 4 or 10. A expensive gamble ( New key head + Programming) to test a idea.
Does anyone know what pin 4 and 10 are for ?
Is there any other way of checking these pins ?
Cheers
Looking in the factory service manual for the Low series BCM pinouts. Pin 4 and pin 10 on Connector YB134 are not used on a LOW series BCM.
Looking at the BCM PCB , these pins have circuits on the PCB .
What I was thinking, is there any way of testing if pins 4 and 10 they are active ?
The reason I am asking this is , I have a VS Ute with a Hard lid and was going to put remote locks on the hard lid.
I heard with the newer VU-VZ utes . when fitting remote locking for a Hard lid . It can be linked up to a 3rd button on a 3 button remote key head.
My VS Ute came with a 2 button key head. This got me thinking about the VS Calais and Statesman with their remote boot release. Maybe I could hook the hard lid remote locking up to the boot release pin.
Then looking at the VS high series BCM. It has a pin for remote boot release. But the VS low series BCM doesn't have a pin for the boot release
That got me thinking about the Pin 4 and Pin 10 of a LOW series BCM. wishful thinking that Holden omitted this from the service manual.
I wonder if either PIN 4 or 10 give a signal if a 3 button remote is used???
The only way I thought of testing my theory is to Buy a 3 button remote , and get it coded to my car. Then cross my fingers and push the 3rd button on the remote and hope there is a signal produced at pin 4 or 10. A expensive gamble ( New key head + Programming) to test a idea.
Does anyone know what pin 4 and 10 are for ?
Is there any other way of checking these pins ?
Cheers