Kalmaker 3Bar VE Table XDF
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Kalmaker 3Bar VE Table XDF
yeah would be just a setting in tunerpro to reverse the rows.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: Kalmaker 3Bar VE Table XDF
i allways run rpm from the bottom up so it matches the graphs lol
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Kalmaker 3Bar VE Table XDF
yeah me too!
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
-
- Posts: 2883
- Joined: Sun Aug 02, 2009 9:16 pm
- Location: Bayside, Melbourne, Victoria
- Contact:
Re: Kalmaker 3Bar VE Table XDF
I didn't understand when DW said it but when H202T said he preferred it to made me think WTF...
Peaks showing high when on load...
Makes sense & understand now but all is what your used to seeing I guess!
Thanks for the reference & input guys!!!
Peaks showing high when on load...
Makes sense & understand now but all is what your used to seeing I guess!
Thanks for the reference & input guys!!!