Page 1 of 1
Kalmaker
Posted: Sat Oct 01, 2016 3:21 pm
by Ferett
Ive located a kalmaker set up to tune delcos,
Its got the red box and lead to connect to laptop,
Just after some info on what else i need?
What do i need to load onto the laptop?(programmes)?
Re writable chips?
Re: Kalmaker
Posted: Sat Oct 01, 2016 6:14 pm
by MAGP
At a bare minimum you will need software. You may be able to use TunerPro RT but someone else (Antus, Dylan, VL400, etc) will know for sure. If you can't use TunerPro RT will will need to identify the ECM/PCM you have and then purchase the specific Kalmaker software for it. If it is an 808 you will need SP3 (or if you are really unlucky SP2) if it is something else you will need either SP3 or one of the Workshop series.
Re: Kalmaker
Posted: Sat Oct 01, 2016 6:24 pm
by Dylan
You will need there software and dongle to match. As they're programmed to go with each other.
Re: Kalmaker
Posted: Sun Oct 02, 2016 4:58 pm
by antus
If its an 808 an includes the nvram and if its not too old and still working you'd be best of getting an eeprom programmer and putting our 12p software on it. Less hoops to jump through. Your choice though.