vr v8 turbo base tune

[delcowizzid]

looks like you need to set single fire mode at low pulsewidths the injectors probably not liking so low of a pulsewidth one minute they are struggling to open at all then bpw goes high enough due to ve change and bam they open.get dylan to set the narrow pulsewidth high and low settings in the top window of tunerpro to say 2ms and 3 ms just till you get it idling good and clean

[Dylan]

Well worth a try good idea to. I haven't looked at the bin yet. Just assisted with the injector data tables.

[delcowizzid]

I would of changed it and reuploaded but only had time for a quick look at the log and back to my movie lol

[Dylan]

What's on tonight? Titanic?

[delcowizzid]

Popcorn time movies streamed heaps tonight lol

[VL400]

I was using the 2bar adx but it wouldn't let me connect with the aldl in tunerpro so I changed back to the 1bar adx. I was assuming with the 2bar map selected it would still be ok?

You must use the 2bar ADX still, the MAP value displayed will be half actual using the 1 bar ADX. You can playback your XDL file with the 2 bar ADX to get the correct values.

The 2bar and 1bar ADX are very similar so should work, the default config is setup for use with the OSE plugin. Can you try the attached? Made some minor changes, but nothing that should fix it as the connection and processing stuff is all the same as the 1 bar ADX.

[Wade]

thanks vl400. I'll give it go

[vlt304]

i had to go single fire with 42lb injectors in my 304 for it to run and start fires up like a stock engine no dramas.

[Dylan]

What ms values did you run?

[vlt304]

the bin is on my other laptop i will boot it up in a min and grab it