Re: Macca's thread
Posted: Sun Aug 06, 2017 2:49 pm
short motor is together, just wish i had the money to balance it, but apprentice budget aha,
time to start giving the heads a clean up,
ordered a degree wheel, so i can dial the cam in, if its to small i might go a crane 284 or the camtech equivalent, but get it ground with a 110 lobe separation angle,
get the motor together than get headers, and either wait to get the 5speed or find a turbo pattern bellhousing to put on the 4speed and run it
time to start giving the heads a clean up,
ordered a degree wheel, so i can dial the cam in, if its to small i might go a crane 284 or the camtech equivalent, but get it ground with a 110 lobe separation angle,
get the motor together than get headers, and either wait to get the 5speed or find a turbo pattern bellhousing to put on the 4speed and run it