DELCOS NEW RIDE
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: DELCOS NEW RIDE
Vb went on the dyno again today to test a genuine garret 3540 in a 1.06 housing off a you know what DROF haha solid 20+rwkw gains everywhere at the same boost. 20 degree higher iat's though. Also tested pre cooler pressure vs intake manifold pressure 1.5-1.8 psi more on the hot side so it's still flowing pretty damn good at getting close to 700 crank hp haha
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
- vlad01
- Posts: 7806
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: DELCOS NEW RIDE
Fair effort.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: DELCOS NEW RIDE
what did you have before a .82 housing ?
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: DELCOS NEW RIDE
0.84 twin scroll. Don't know if the turbo is dead from racing or convertor can't stall it up now just sits at 3psi lol
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: DELCOS NEW RIDE
i was going to ask how much difference the larger rear made to spooling it up, but it sounds like thats the least of your issues :S
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: DELCOS NEW RIDE
massive hole in the crossover haha that's why it got loud mid dyno run should be back to boosting this week lol
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem