Page 1 of 1
Ford EEC IV / EEC V, 1986-2004 reading / writing
Posted: Thu Oct 05, 2017 12:02 pm
by andy18
Hello, does anyone know if anything exists out there to read write these ECUs via J3 port? I need the whole memory with VID block for cloning purposes.
I used to swap the Intel / FoMoCo memory chip buy maybe it is possible to read / write it?
Thank you, Andy
Re: Ford EEC IV / EEC V, 1986-2004 reading / writing
Posted: Thu Oct 05, 2017 2:58 pm
by VX L67 Getrag
Hey Andy,
I've searched long & hard for how to do it also & didn't know the ford mo chip could be replaced to do it as I was told it uses multiple chips for the 1 complete file?
But with EEC-V so AU only onwards I think from memory they can be done with clone tools via the OBDII port!
Re: Ford EEC IV / EEC V, 1986-2004 reading / writing
Posted: Fri Oct 06, 2017 12:00 pm
by andy18
VX L67 Getrag wrote:Hey Andy,
I've searched long & hard for how to do it also & didn't know the ford mo chip could be replaced to do it as I was told it uses multiple chips for the 1 complete file?
But with EEC-V so AU only onwards I think from memory they can be done with clone tools via the OBDII port!
One chip only on my 2000 Ford 7.3L diesel.
andy