NVRAM Not working
Posted: Tue Feb 27, 2018 8:53 pm
HI All
Car is a VT L67
I have a new PCM NVRAM & am having problems with it not working & I can't write to it either.
Originally it showed up as a blank chip before fitting to the car, after trying it in the car i couldn't get it started & sounds like high speed fans are on.
I tried reading it again today & it does have info on there basically full from top to bottom.
I then tried to write to it with the bin copy that I am using in the car but it won't write i get a write failed error with an address.
The bin file the car is running on is The1's enhanced file & it starts later in the page when looking in the buffer on the GQ 4x4 also there are lots of empty spaces on the right hand side of viewer.
I then put the RW jumper on thinking this has to be connected for the programmer to write I couldn't find anything about it reading through the forum then the start of the file had moved further down the page, I tried to write the original file back that I saved previously but it also wont write.
I don't know that much but am trying to learn & don't know how to get it going.
Any help would be appreciated thanks in advance.
Car is a VT L67
I have a new PCM NVRAM & am having problems with it not working & I can't write to it either.
Originally it showed up as a blank chip before fitting to the car, after trying it in the car i couldn't get it started & sounds like high speed fans are on.
I tried reading it again today & it does have info on there basically full from top to bottom.
I then tried to write to it with the bin copy that I am using in the car but it won't write i get a write failed error with an address.
The bin file the car is running on is The1's enhanced file & it starts later in the page when looking in the buffer on the GQ 4x4 also there are lots of empty spaces on the right hand side of viewer.
I then put the RW jumper on thinking this has to be connected for the programmer to write I couldn't find anything about it reading through the forum then the start of the file had moved further down the page, I tried to write the original file back that I saved previously but it also wont write.
I don't know that much but am trying to learn & don't know how to get it going.
Any help would be appreciated thanks in advance.