pcmhacking.net

https://www.ebay.com.au/itm/EZP-2010-Se ... SwNgdZmUG2

What do ya reckon Tassie? I'm assuming the programmer and clip are both suitable?

Youll need to read up on that device and check it supports whatever devices you need. Also check if it actually includes free software.. which is not full of viruses ect. Thats one of the more annoying yet comon thing with cheap stuff out of china. Thats obviously coming from Aus, but they are just a middle man for the shit from china.

I used freeware which was compatible with my oldschool serial based programmer back in the day.

I'd get the TL866cs, the genuine software from the autoelectic.cn is good. Can get a 3rd party clip.

Retro, Did you try the Arrow software mate?

and have you seen this thread or the attached spreadsheet?

http://www.ls1gto.com/forums/showthread ... 77&page=13

(I am sure all this is already on this site somewhere, but will put up for context or to help others looking later)

Is there another version that's compatible with our VZ clusters?

madmaxisback wrote:Retro, Did you try the Arrow software mate?

and have you seen this thread or the attached spreadsheet?

http://www.ls1gto.com/forums/showthread ... 77&page=13

(I am sure all this is already on this site somewhere, but will put up for context or to help others looking later)

As of today I have been able to loan a known working cable, it's one of tazzi's cables.

So I have turned police mode on, and it works HOWEVER.... i can't listen to the aldl chatter using ose flash and use the arrow software at the same time, the arrow software just doesn't wanna play when you go and enable comms (only way I could seem to get arrow to work), I had to close ose flash before arrow would play. Any suggestions?

I have seen that thread but not the spreadsheet, shall have a quick look now.

Use sudt accessport to log serisl comms and not ose flash tool. Sudt works in the background so doesnt fight opening the port

Tre-Cool wrote:

Dylan wrote:Anyone ever found the arrow software?

been here since 2015 when i first uploaded it.

http://www.vyssute.com/downloads/VY-Dash/

Word of warning, u can corrupt the dash config if you send it silly things or apply it to vz clusters.

hey mate what username and password do you use to access the arrow program once downloaded? cheers

seanlivingstone wrote:

Tre-Cool wrote:

Dylan wrote:Anyone ever found the arrow software?

been here since 2015 when i first uploaded it.

http://www.vyssute.com/downloads/VY-Dash/

Word of warning, u can corrupt the dash config if you send it silly things or apply it to vz clusters.

hey mate what username and password do you use to access the arrow program once downloaded? cheers

not needed, just close that box and off you go!

antus wrote:Use sudt accessport to log serisl comms and not ose flash tool. Sudt works in the background so doesnt fight opening the port

Now that the long weekend is here and I have time to keep playing with this again given that every single store is shut.... I might be doing something wrong within that program but I still can't log serial comms and connect to the cluster through the arrow software at the same time.