Page 1 of 1
Vy flash
Posted: Sun Jul 22, 2018 6:59 pm
by nutbag355
Hi all, is it possible to flash a vy v6 pcm out of the vehicle, and if so what do I need to set it up? I have been asked if I’m able to disable vats for a conversion. Is is as simple as power/earth/aldl enable wires?
Re: Vy flash
Posted: Mon Jul 23, 2018 2:20 pm
by Holden202T
you'll need constant power and ignition power plus grounds, and you'll need the wires for the aldl plug also and i think that should be all you need.
Re: Vy flash
Posted: Tue Jul 24, 2018 6:35 am
by nutbag355
Awesome. Thanks mate. I was hoping that’s all that’ll be required.
Re: Vy flash
Posted: Tue Jul 24, 2018 5:36 pm
by oldn64
nutbag355 wrote:Awesome. Thanks mate. I was hoping that’s all that’ll be required.
Obviously you will need PC, tuning software and aldl cable interface as well.
Tell us more about the conversion too.
we are all car nuts after all!!
cheers
oldn64
Re: Vy flash
Posted: Tue Jul 24, 2018 7:22 pm
by efid
Whos the best to get the hardware required to do this sort of thing.
Re: Vy flash
Posted: Tue Jul 24, 2018 7:28 pm
by oldn64
efid wrote:Whos the best to get the hardware required to do this sort of thing.
Welcome aboard efid,
all of the things can be sourced through the website here.
What are you hoping to do and with what?
Cheers
oldn64
Re: Vy flash
Posted: Tue Jul 24, 2018 7:53 pm
by efid
Adding it to the current vehicles I can tune as I run a dyno and have need to fill a hole. Havent searched much before as I have had enough to do but now just looking at expanding a bit more.
Re: Vy flash
Posted: Wed Jul 25, 2018 8:31 am
by nutbag355
oldn64 wrote:nutbag355 wrote:Awesome. Thanks mate. I was hoping that’s all that’ll be required.
Obviously you will need PC, tuning software and aldl cable interface as well.
Tell us more about the conversion too.
we are all car nuts after all!!
cheers
oldn64
Hey mate, not sure on the conversion but can find out
And yep, already have all the hardware and software required to preform the task. Will try and keep you posted