Page 1 of 1
How do you identify a 5.7lt Holden motor in a VS?
Posted: Sun Nov 25, 2018 7:08 pm
by Gareth
Wondering if anyone out there knows how to identify a Holden stroker motor without stripping it? Do engine numbers tell something? Other than the PCM and a badge I'm not sure if the motor in my VS grange is a stroker or not, the car was originally not a stroker car.
Any ideas?
Re: How do you identify a 5.7lt Holden motor in a VS?
Posted: Sun Nov 25, 2018 8:51 pm
by Comcal76
To find out if it's a stroker remove a spark plug and measure from tdc to bdc of stroke, 304 = 3.026 and 350 = 3.48".
Re: How do you identify a 5.7lt Holden motor in a VS?
Posted: Mon Nov 26, 2018 10:11 am
by Jayme
also strokers have bigger injectors. the injector part number and memcal code would be a really easy place to start. if its got 19lb injectors its either not a stoker or would be super lean and not running right lol.
Re: How do you identify a 5.7lt Holden motor in a VS?
Posted: Mon Nov 26, 2018 10:21 am
by Gareth
I think a stoke measure to be sure like comcal76 suggested will be the only sure way.
The injectors are orange top, the PCM was fitted with BWFW (5lt manual) in a BWCT case (5.7lt auto) when i got it
It certainly didn't run well when I got it.
Re: How do you identify a 5.7lt Holden motor in a VS?
Posted: Mon Nov 26, 2018 1:15 pm
by VK_3800
There are exceptions and it could have been re-stamped, but the engine number prefix for VR/VS strokers is VL where (most) VN-VS standard engines are VU prefix
Re: How do you identify a 5.7lt Holden motor in a VS?
Posted: Mon Nov 26, 2018 9:38 pm
by VX L67 Getrag
Not to mention we all know there's those nasty drilled injectors out there, although a file read with comparison to correct injector rate for cc size would sort that out!
Is there an easy way to get stroke length with spark plug hole not giving a good angle to get full length on most V8 angles?
Re: How do you identify a 5.7lt Holden motor in a VS?
Posted: Tue Nov 27, 2018 4:58 pm
by Gareth
The engine number starts with VU, I'm fairly certain now that the only thing that is a stroker is the person who fitted the PCM, Memcal and rear '215' badge....
Now to set about de stroking it
Re: How do you identify a 5.7lt Holden motor in a VS?
Posted: Tue Nov 27, 2018 5:18 pm
by Dylan
I was under the impression that the factor stroker was a VU motor still? No doubt I'm wrong.
Re: How do you identify a 5.7lt Holden motor in a VS?
Posted: Tue Nov 27, 2018 6:22 pm
by Comcal76
Holden engine Identification
https://www.uniquecarsandparts.com.au/h ... ne_numbers
VL xxxxxxxx is stroker engine.