pcmhacking.net

Boost VE breakpoints for 3 bar....

The scaling starts at 100kpa and goes all the way up to 400kpa, this doesn't seem right to me. Is the conversion goofed or can I change it to 110-300kpa to gain some resolution?

You probably have the map sensor selector boxes ticked wrong if it says 400 should be 100-300 .You need to make sure the 100kpa colomn is a copy of the 20-100 kpa tables 100kpa colomn

Thanks DW! I had the first bit selected as well as the second bit. Deselected the first bit and now the tables look like they should. Sorry for all the newb questions, ill add notes to the XDF and post it up when finished.

antus wrote:Its not a feature ive used but i think the ose tool will set up the tables and generate and xdf for the configuration you have set. So you could edit the equastion in the xdf to use mph instead of kph. We figured that out kph to mph equasions here
viewtopic.php?f=8&t=5591&p=83333#p83313

I ended up stealing the definition from that thread since most of the labels have been changed to indicate imperial measurements.

Before I go messing up something, I need to make sure that it will be correct.

I noticed some of the tables are still labeled with metric numbers. Will it be ok to convert those labels without messing up anything else?


Thanks

Labells in xdf and adx colomn are fine to change just make sure they are correct and matching so bubble tracimg etc goes on the right cell

Thanks DW. Is there any way I can check if the tables are using the correct conversion? The scalers are set but the tables only show the conversion for the field.

Fried the ECM last night. O2 ground wire was hot only to find out that it was connected to the starter solenoid. On this car the O2 ground is bundled with the power wires to the harness, so it was a dumb mistake. Melted the ground cavities on the connectors so I need to replace those. Another ECM ordered and should be here in a few days.

Ouch lol make a good poof or just pretty boring smoke escape lol

Just smoke and melted the D1 pin off from the ECM. I caught it quick enough before it melted anything else lol

Plugged in, loaded bin, pulls data but no start. Timing light flashes, power to injectors. Gotta be something stupid I set wrong in the bin.

Only thing I'm not sure about is the ref angle. It's 60* in the starter bin so I set it to 5.98 to match my base timing. I feel like that might be an issue.