Holden V8 getting an update
Posted: Sat Aug 10, 2019 5:20 pm
Finaly getting around to fitting one of VL400 ignition modules that I’ve had for about 2 years and done nothing with. Going crank trigger and LS coils
pcmhacking.net
Electronic Fuel Injection - Developement & Tuning
https://pcmhacking.net/forums/
Holden V8 getting an update
Page 1 of 2
Re: Holden V8 getting an update
Posted: Sat Aug 10, 2019 5:38 pm
Is that fire in the middle to keep you from freezing?
Re: Holden V8 getting an update
Posted: Sat Aug 10, 2019 5:42 pm
Just the reflection of the heat lamp, it’s so cold in Melbourne/ most of Aus today
Re: Holden V8 getting an update
Posted: Sat Aug 10, 2019 6:21 pm
Module you ‘had’, yeah 
That reference isn’t legal btw...
That reference isn’t legal btw...
Re: Holden V8 getting an update
Posted: Sat Aug 10, 2019 6:24 pm
It’s in a commercial stubby holder, fully legal. And yes when I get my module back off you I’ll have one lol
Re: Holden V8 getting an update
Posted: Sat Aug 10, 2019 6:57 pm
Stubby holder is to keep beer warm and stop it from freezing in the garage today.
Re: Holden V8 getting an update
Posted: Sat Aug 10, 2019 7:34 pm
Should of got a Lucas fridge then.
Re: Holden V8 getting an update
Posted: Sat Aug 10, 2019 8:12 pm
Nice bench top
Re: Holden V8 getting an update
Posted: Sat Aug 10, 2019 8:29 pm
All surgical tables should be stainless
Re: Holden V8 getting an update
Posted: Sun Aug 11, 2019 4:33 pm
Nice. the 36 -1 wheel looks kinda familiar. I too have had the same module here gathering dust for the same purpose 
Hopefully once this shoulder is sorted I'll finally make some progress.
Hopefully once this shoulder is sorted I'll finally make some progress.