Page 15 of 57
Re: 253 V8 carby selection
Posted: Mon Jun 14, 2021 11:33 am
by Madmatt2006
I'll take it to super balance they do this type of work. I have a Soarer auto tailshaft some where also. I changed the the bushing today is that in far enough?
had big plans of getting the gearbox on today but the thrust bearing they sent with clutch kit won't fit it's to small!
Got engine bay done also
Before pictures
after
Re: 253 V8 carby selection
Posted: Mon Jun 14, 2021 11:48 am
by 'quipt4it
.
Re: 253 V8 carby selection
Posted: Mon Jun 14, 2021 11:56 am
by Madmatt2006
From the ad for the clutch kit
https://www.ebay.com.au/itm/360101787646 the thrust bearing should fit my gearbox hey? The hole in the bearing is to small.
Re: 253 V8 carby selection
Posted: Mon Jun 14, 2021 11:57 am
by 'quipt4it
.
Re: 253 V8 carby selection
Posted: Mon Jun 14, 2021 11:59 am
by Madmatt2006
ah ha they mention in red!
"important please note :
Thrust bearing supplied in this kit is an early Holden type
GSB-222 As pictured"
wrong one!
Re: 253 V8 carby selection
Posted: Mon Jun 14, 2021 12:08 pm
by Madmatt2006
I'm confused which thrust bearing will suit Delow fork and gearbox
Re: 253 V8 carby selection
Posted: Mon Jun 14, 2021 12:12 pm
by 'quipt4it
.
Re: 253 V8 carby selection
Posted: Mon Jun 14, 2021 12:22 pm
by Madmatt2006
I guess Dellow would have one since all of the conversion kit is from them
Re: 253 V8 carby selection
Posted: Mon Jun 14, 2021 12:47 pm
by 'quipt4it
.
Re: 253 V8 carby selection
Posted: Mon Jun 14, 2021 1:04 pm
by Madmatt2006
I stumbled across the one you mentioned on eBay it would have to be the right one for sure? it's expensive
. With the thrust bearing and Dellow fork is there a clip to attach it? like there was on the fork and thrust bearing off the supra below.