pcmhacking.net

Ok so what should i do delcowizzid?

I'm pretty sure in the $11p package there was a start tune for L67 as I had done one with VS L67 & the VS L67 box behind it.

Vx L67 getrag
Mines in a vr with complete L67 motor and using vr 4l60e and vr ecu

If that tune you talk about exists can I copy the timing maps and fuel settings and ve table to get me going?
Or cause it's vs and uses a maf it's gonna be out also?

It's a bin created to run the L67 on the VR computer hence $11P custom code.

It will run the early 4L60E without the TCC controlled by PWM or can also run the later 4L60E that has TCC with PWM control & the area to change those settings is in between $5219 & $548D need to be copied across to allow for it to work properly!

So the bin you just posted is for a l67 engine in a vr running a vs 4l60e?
Any chance you can change the auto setting for me to suit my vr 4l60e . As it is beyond my skill level in tuner pro.
Thanks so much for this

with info I was given this should do the trick!

vx l67 getrag thanks mate

About to buy a aldl cable of here to go with my old school moates ostrich.

Fired up your custom tune vx l67 getrag and looks like the timing maps are a bit scattered.
Ve fuel table i can sort out with my wideband no worries
But the timing boost table should i use this vt super 6 table below?
I mean the 450 onwards table part of vt super 6 map looks like its boost onwards as its pulling timing slowly. Should i drop this into my 11p boost part of map to get me going ?
See pics below
sorry about all the questions

That appears to be the stock vr spark table in the 2nd pic.

It's just a file that was created to get to a start point, so adjust fuel & timing as needed & it won't directly relate to the standard L67 files as there created for MAF & not MAP.

20 degrees everywhere on boost won't be nice haha