FS: '808 Looms (N13 & VN/VP), ECU, Sensors
Posted: Sun Jan 10, 2021 8:35 pm
N13 Pulsar loom, uncut. (port injection so it has 4 injector plugs, you can add another 2 or 4 in parallel for V6/V8) $70
VN/VP loom, uncut. Came out of a 3800 V6 Auto. $80
Delco ECU (from an Opel Corsa, same as an '808 minus the second IO driver - No A/C control output, possibly some Flex outputs not available too. Analog inputs all present [wideband etc]). Currently running 12P but will be sold with 4Cyl Memcal. $55. USB comms and Write Enable wiring for NVRAM can be added for $40.
Delco '808 ECU. Currently running 12P but will be sold with V6 Auto Memcal OR 4Cyl Memcal. $70. USB comms and Write Enable wiring for NVRAM can be added for $40.
GM 1Bar Map sensor $15
Chinese 2Bar MAP sensor $20
Coolant Temp Sensor $10
Air Temp Sensor $10
GM O2 sensor (Not wideband) $5
N13 Distributor with spare GM connectors (cut off with an inch or two wire length) - Use the whole distributor in your Pulsar/Astra, mod it for a direct fit into a VW or use the pickup module to interface the '808 with your reluctor pickup & drive your coil. Connects direct to a N13 loom without any splicing. $50
Postage will be cost price. Located near Goulburn NSW.
Please let me know if any of these prices are unreasonable, it's been quite some time since collecting them for various projects. Prices Negotiable.
VN/VP loom, uncut. Came out of a 3800 V6 Auto. $80
Delco ECU (from an Opel Corsa, same as an '808 minus the second IO driver - No A/C control output, possibly some Flex outputs not available too. Analog inputs all present [wideband etc]). Currently running 12P but will be sold with 4Cyl Memcal. $55. USB comms and Write Enable wiring for NVRAM can be added for $40.
Delco '808 ECU. Currently running 12P but will be sold with V6 Auto Memcal OR 4Cyl Memcal. $70. USB comms and Write Enable wiring for NVRAM can be added for $40.
GM 1Bar Map sensor $15
Chinese 2Bar MAP sensor $20
Coolant Temp Sensor $10
Air Temp Sensor $10
GM O2 sensor (Not wideband) $5
N13 Distributor with spare GM connectors (cut off with an inch or two wire length) - Use the whole distributor in your Pulsar/Astra, mod it for a direct fit into a VW or use the pickup module to interface the '808 with your reluctor pickup & drive your coil. Connects direct to a N13 loom without any splicing. $50
Postage will be cost price. Located near Goulburn NSW.
Please let me know if any of these prices are unreasonable, it's been quite some time since collecting them for various projects. Prices Negotiable.