Injector Flow Bench with Enhanced Mod VS V6
Posted: Tue May 04, 2021 8:12 pm
Someone asked me about this so i thought id just post it up for all to use.
This is my modded code to run an injector flowbench. The code is basic but runs behind the Engine Runtime output code, you can see the runtime even in factory setup in the adx, when the engine runtime reaches the preset scalar time set in the xdf it will invoke the fuel cut code to switch the injectors off, you can reset the engine timer to zero by making pin A5 high, the timer will still loop 0-255 and start again by default if left.
Of coarse you need to take care of the psu, maf input, 8x for rpm so you can make the ecu run and set the desired RPM and injector pulse time via the MAF input.
Big thread here when i getting it all to work, you can see my setup using a cheap Chinese flow bench and modding it.
viewtopic.php?f=31&t=3377&p=48233&hilit ... nch#p48233
This is my modded code to run an injector flowbench. The code is basic but runs behind the Engine Runtime output code, you can see the runtime even in factory setup in the adx, when the engine runtime reaches the preset scalar time set in the xdf it will invoke the fuel cut code to switch the injectors off, you can reset the engine timer to zero by making pin A5 high, the timer will still loop 0-255 and start again by default if left.
Of coarse you need to take care of the psu, maf input, 8x for rpm so you can make the ecu run and set the desired RPM and injector pulse time via the MAF input.
Big thread here when i getting it all to work, you can see my setup using a cheap Chinese flow bench and modding it.
viewtopic.php?f=31&t=3377&p=48233&hilit ... nch#p48233