pcmhacking.net

as the title says im after a used scania eddy current retarder for a little project preferably in NZ they weigh about 300kg LOL

WTF?!?!?!

makin your own dyno there hey delco, have you checked out the wreckers yet?

hehe yeah engine dyno on the go. finding it hard to tune high boost on the street and have a couple of projects that umm stick out on the street you could say LOL built for straight lines only.have a mate who fixes scania busses hopefully he just has one lying in the scrap somewhere but i doubt it .they are a touch expensive brand new

Hey Delco,

If you find a second one or one in Australia that you don't want let me know. I currently have a Vane rolling road with air powered disk brakes. I have built my own computer based controller for it to do closed loop speed control and data logging etc but I'm finding the air brakes don't respond quick enough.

Cheers

Daniel.

I have a telma retarder 310 model i think from memory, not sure if i want to get rid of it tho

I did another post about my dyno also, https://pcmhacking.net/forums/viewtopic.php?f=36&t=208

What i would really like to do is get involved with someone in melbourne who shares the buzz

I wanted to pull the water brake off the chassis dyno and make an engine dyno, then fit the telma to the chassis dyno; but i just dont have the time.

If any one feels they were keen to continue the project, i would support it

im currently looking for telma retarder in AU as well something around cc135-cc160 ish

TTVN wrote:im currently looking for telma retarder in AU as well something around cc135-cc160 ish

i picked this up for $1000

Thread dig
Just found this on gumtree https://www.gumtree.com.au/s-ad/campbel ... 1135200826

then set these up for your rollers lol
https://www.gumtree.com.au/s-ad/campbel ... 1143142148