pcmhacking.net

Hi there, chasing a VR engine loom so I can practice programing a VR ECM. So it will be used for bench testing to start with and then later on, if all goes well, I will convert the loom to run a turbocharged 1915cc VW Superbug.

Also after the ECM plugs to suit the VY computer. That engine is going into a Transit van with a modified loom (Castlemaine Rod Shop). I would like to bench test this ECM as well.

I live in Tasmania.

Cheers
David

Vr manual loom is pretty much identical to a vn loom it's just missing the 8192 baud aldl output wire to the diagnostic plug and the speed sensor comes through the floor on vn and up into the engine bay on vr

Thanks for that info. Might help me locate a suitable loom.
Cheers