Guessing plugs on loom
Guessing plugs on loom
I picked up a VP engine loom, and as I didn’t get to be the one that removed it I have been guessing which plug go’s where.
I’m down to three, one of which has the same plug as a injector.
I’m down to three, one of which has the same plug as a injector.
Re: Guessing plugs on loom
Assuming it’s a V8 loom, the injector type connector should be ignition coil, the green wire with the female barrel connector is the A/C compressor, the green wire with the female blade is temp sender.
According to chemistry, alcohol is a solution...
Re: Guessing plugs on loom
It’s a V6 loom.
Re: Guessing plugs on loom
With injector looking plug the white wire is going here to the 6 pin control plug.
- Attachments
-
- A9181B45-6E7C-4796-9817-2147EC70ACC5.jpeg (223.6 KiB) Viewed 6464 times
Re: Guessing plugs on loom
And the brown wire is going here to the 8 pin control plug.
- Attachments
-
- 709D0A11-A4CD-477E-BC57-874FF97A79EC.jpeg (239.64 KiB) Viewed 6464 times
Re: Guessing plugs on loom
After stripping more back I found a extra Tacho signal wire which was hidden in the tape.
Re: Guessing plugs on loom
Where did you get those documents from?
I'd love to get a hold of them
I'd love to get a hold of them
Re: Guessing plugs on loom
All off this forum mate.Dylan wrote:Where did you get those documents from?
I'd love to get a hold of them