Help understanding BLM scaler tables
Posted: Sat Feb 11, 2023 11:42 am
Been sorting out fueling and doing some logs. I have turned off Lean Cruise and I have been told to turn off closed loop by adjusting scale temps to 150 degs.
But looking at the BLM scalers it looks to me I should be setting them the other way (lower temp). So looking at the 2 tables:
"BLM low coolant temp cutoff" =85.25 degC
"BLM high coolant temp cutoff" = 110 degC
Closed loop will only activate between 85.25 C to 110 C. Anything below low temp cutoff and above high temp cutoff, Closed Loop will not be active?
So shouldn't I set "BLM Low temp" to say 0 degC and the same for BLM High temp"?
I'm a little confused and want to do this correctly.
Using The 1's $A6E enhanced
But looking at the BLM scalers it looks to me I should be setting them the other way (lower temp). So looking at the 2 tables:
"BLM low coolant temp cutoff" =85.25 degC
"BLM high coolant temp cutoff" = 110 degC
Closed loop will only activate between 85.25 C to 110 C. Anything below low temp cutoff and above high temp cutoff, Closed Loop will not be active?
So shouldn't I set "BLM Low temp" to say 0 degC and the same for BLM High temp"?
I'm a little confused and want to do this correctly.
Using The 1's $A6E enhanced