pcmhacking.net

Hi guys

I'm am wondering if someone can point me in the rite direction to get communication with my tuning setup.

Vehicle is a VS Statesman 5.0lt Auto
Realtime PCM with the Nvram. Dallis Chip.
Programed with no offset vehicle starts and runs.

New ALDL interface and cable purchased as I suspected my others may have been letting me down.
Tuner Pro RT version is 5.00

ADX $11B and ive tryed p
XDF $11B

I feel like I am close but something obverse is stopping me from detecting the hardware.
Cable Echo is ticked in the plugin settings menu.
Com port is correct.
OSE Plugin is used.

Can someone assist me with this issue.

You should be using the ADX and ADX from the 11P zip (look for the link in the FAQ area, link up near top right).

But even without that it should detect. When you say runs, is the car stock? Does it run well enough that you think the nvram is running the car and it is not in limp home backup mode?

Hi Antus.

Yes that is the VR_ $11_v1.01 i am using.

Engine is modified with cam mild cam. Vehicle starts and runs fine and is not in limp mode.
I have gone though all of Ashley's Folders and confirmed that all the jumpers and Chip is programmed properly.
Can the Dallis Chip allow the vehicle to run but not accessed somehow?

It must to be an issue with Config........ I have tested and tried different config set ups and different versions of tuner pro still having the same result.

Im not sure what to do next.

FAQ: viewtopic.php?f=7&t=1396
11P: viewtopic.php?f=27&t=3798

not VR_ $11_v1.01