pcmhacking.net

Posted: **Sat Apr 05, 2025 7:33 pm**

Can someone confirm this, or I am only one with this problem?
If I set any application to listen CAN messages with VCX nano connected to E78 ecu, application crash after few seconds.

Tested so far:
Universalpatcher->Logger->Analyzer
J2534Tool (VX Manager->Diagnostic->Passthru->Run)
https://github.com/jakka351/J2534CANbusTool

I don't know where the problem is: E78, Vxdiag/passthru driver or my PC. So, testing with another ecu with CAN protocol may help, too.

btw. Vxdiag driver policy is horrible, can't recommend buying it - crash or not.

Posted: **Sun Apr 06, 2025 12:03 pm**

First step in troubleshooting anything that involves a vxdiag is throw it away and watch all your problems be solved

Posted: **Sun Apr 06, 2025 3:20 pm**

beeradoc wrote: ↑Sun Apr 06, 2025 12:03 pm First step in troubleshooting anything that involves a vxdiag is throw it away and watch all your problems be solved

pcmhacking.net

Vxdiag vcx nano crash with CAN ecu?

Vxdiag vcx nano crash with CAN ecu?

Re: Vxdiag vcx nano crash wit CAN ecu?

Re: Vxdiag vcx nano crash wit CAN ecu?