4l60e upshift start and end ratios 7603
Posted: Mon Jun 30, 2025 2:14 am
There are parameters that I think affected to torque management timing
Upshift start ratio
Upshift end ratio
Anyone tried to change it ? In annotation "used to calibrate high stall converters"
My goal is to make torque reduction ramp in and out earlier because now reduction jumps in when 2-3 shifts already done
Upshift start ratio
Upshift end ratio
Anyone tried to change it ? In annotation "used to calibrate high stall converters"
My goal is to make torque reduction ramp in and out earlier because now reduction jumps in when 2-3 shifts already done