Nice too see you still have the 300 mate

Hi Guys, not sure if this is in the correct thread? i have a question i have done a ls1 conversion in to a vp calais car was a ex 5ltr Now my tachometer is reading incorrect compared to my odb2 via my phone i do know there is a value that needs to be changed in the tune when your using hptuners or e...

Hi guys got a question?

I have a vs v6 and the 4l60e is on its last legs I have a fresh reco 4l60 sitting at home that I would love to put in . What would been needed to do this conversion ? Use a manual memcal ? Or auto codes switched off tcc lock up and gear shifts and fix incorrect speedo

VL400 everything you have stated i have done this time and last time but also i tried it again later on and the engine fan would come one a soon as the ignition was on to acc so now i do not know wtf is going on might pull the board out of the socket and check pins i hope its not damaged again . if ...

Hey guys got a issue

I am Using TP5 8383 with OSEplugin 1.49 and i can not get it to connect to my vp v8 nvram ecm i got it back in the mail today from VL400 and worked when he tested it .

my Flashtool v145 works so i am unsure what i am doing wrong

Holden202t it is connect with usb and VL400 i will check that out today i am having the same issue as last time when i sent the setup back to you and had a diode that has been nocked off the board

hi guys i am having a issue trying to connect to my nvram in a vp calais 5ltr it worked last year when it was hooked up in a turbo v6 . but for some reason can not get my laptop to connect to the ecu i do not know what is going on and it really sucks i dont know if my laptop is crap and giving me co...

well VL400 i have followed all your steps . I get the blue light on the nvram and car runs fine with the 808 comms i get the blue power led when powered then the other leds flash when hooked to my pc i have all the drivers on and comms set correct but when i try the chatter it still doesnt connect y...

Hi Guys you probably get this all the time . But i have just recently purchased a nvram and usb comms 808 board from VL400 i have solderd the 808 wires on to my vn/vp ecu iam installed all my drivers on my lappy and set up flash-tool correct it doesn't pick up my ECU now i don't know if i have done ...

i just wont to have a safe tune done so i can get the car running then i will get the memcal retuned to full potential