Here are the VX V6 L67 PCM wiring diagrams. 05g.pdf 05h.pdf 05i.pdf Cheers mate i downloaded these at the same time from this site to trouble shoot which was great but those only show me the replacement VX loom i have in hand, mine is from a VT that's different slightly, The VX loom doesn't have th...

Hey Guys just need some advice im looking to replace my 98 VT Spac S/C auto engine harness and im struggling to find one from a VT currently but have found a few from a VX S/C assuming from a calais? the seller couldn't confirm. So far i have noticed on the VX loom there is the extra plug for the in...

...i cant see the photo for this one?... This is it. get connected - Copy.jpg The terminal I linked to in my second post is the 150.2 series, however, the p/n you are looking for is 12089290. Just checked PEC Australia in their eBay listings and it is no longer showing (from above picture). I have ...

Easier to buy the short harness for the DFI. That way you have a tight new plug as well: https://www.nikithinka.com/index.php?main_page=product_info&products_id=147915 Have you narrowed the problem down to this? i cant see the photo for this one? but my main goal is to run wires externally with...

Since I am in the states, I have no idea what a VT is. Can you post a pic of the connector? Very likely you are dealing with a pull to seat connector/terminal. Sorry mate a VT ecotec commodore. As the title suggests i want to remove wires from a VT DFI connector but have found so far i can only get...

As the title suggests i want to remove wires from a VT DFI connector but have found so far i can only get the pins to release and push forward from the connector. Is this how they are designed or is there another trick to get them to release and push out from the back of the connector?

I believe this is a 'functionality check' of the solenoids. Page 30 of this PDF will explain: https://www.snapontools.com.au/__data/assets/pdf_file/0008/19259/AUS_Holden_Vehicle_Communication_Software_Manual.pdf It actually tests wiring faults also... Cheers im sure the tech 2 will be able to do th...

Double check on both CAS and CPS that the terminals are pushed in all the way into the sockets of the harness connector, and that none of the wires have separated from the connector terminal by pulling on each individual wire. I have done this when i was told to check the ECU pins earlier on but sa...

It does seem it is running better than it has been, from what you've posted. Wondering if just one of the coils (pair of cyls) has gone out. Are the spark plugs due for a change. When you say running rough, would you describe it as a miss? Brand new plugs, leads etc... and currently its got the spa...

I would do a 'wiggle test' on the 'Ground point under ABS module' in the pic., if you haven't already. The crimping does not look sufficient from the photos. Throw in a couple of star washers for good measure. I prefer crimp and solder. I'm still leaning towards earthing/ connection. Those vanes lo...