265 Hemi to efi
- oldn64
-
- Posts: 256
- Joined: Mon May 28, 2018 5:05 pm
- Location: Country Victoria on a direct road to WINTON
Re: 265 Hemi to efi
heff0018 wrote:Ha it was going great until I snapped a compression ring. The guy from hemi265.com has posted me another one which I hope turns up on Friday.
oh dear


cheers
oldn64
Re: 265 Hemi to efi
All I can say is Its not a good idea rechecking ring gaps late at night after consuming numerous beers.
AnywAy the replacement ring arrived today, the last piston is installed and I will buttoning up the rest of the motor tomorrow.
Cheers
AnywAy the replacement ring arrived today, the last piston is installed and I will buttoning up the rest of the motor tomorrow.
Cheers
- Charlescrown
- Posts: 1351
- Joined: Sat Aug 06, 2011 7:58 am
- Location: Padstow NSW
Re: 265 Hemi to efi
I can remember long time ago I was putting a 454 with super slim rings together and it was due to be freighted to the NT the following day and guess what. Yes ring snapped and the boss was livid. I had a close look at the ring and found a small inclusion that looked like a small ball and it's right where the ring snapped but it didn't help because we had to get another set flown out from the states.
Re: 265 Hemi to efi
To turn a negative into a positive at least I now know at what point of twist a ring will snap
- Charlescrown
- Posts: 1351
- Joined: Sat Aug 06, 2011 7:58 am
- Location: Padstow NSW
Re: 265 Hemi to efi
What's the cogged wheel on the front of the crank for? Ignition trigger?
Re: 265 Hemi to efi
Nothing, its just an old timing chain sprocket I use to run the motor over with.
- Charlescrown
- Posts: 1351
- Joined: Sat Aug 06, 2011 7:58 am
- Location: Padstow NSW
Re: 265 Hemi to efi
Brain teaser.
- oldn64
-
- Posts: 256
- Joined: Mon May 28, 2018 5:05 pm
- Location: Country Victoria on a direct road to WINTON
Re: 265 Hemi to efi
Charlescrown wrote:What's the cogged wheel on the front of the crank for? Ignition trigger?
heff0018 wrote:Nothing, its just an old timing chain sprocket I use to run the motor over with.
Glad someone asked teh question as I was sitting here going, errr that is a timing gear what is it doing on the outside of the timing case..... then I noticed that the pulleys were installed on the in car shot and though ok, temporary or you worked out it needed to be on the inside

Looking good so far, hopefully it will go grrr soon.
Need video of the initial start

cheers
oldn64
Re: 265 Hemi to efi
Fitted up the alternator and clearance to the power steering pump is all good. Glad I took measurements before pullling the motor out.
Just waiting on a new rocker cover gasket that is on back order.
Just waiting on a new rocker cover gasket that is on back order.
Return to Delco ECU Conversions
Who is online
Users browsing this forum: No registered users and 4 guests