P01 '0411 12200411 v6 support

[Holden202T]

no its just a stock VR V6 cam sensor setup.

[Dylan]

Possibly different. I know the V8's running low res mode have a 4X crank trigger and a 1X cam from the dissy and the cam signal is half cam rotation looking at the chopper wheel on them.

[Apples]

Here is a 4.3 V6 low res crank and cam pattern look like.

4.3%20cam%20crank%20waveform.jpg

Here is the V8 low res crank and cam pattern.

V8 cam crank waveform.jpg

[Dylan]

Thanks haven't got the V8 one too have you?

[Apples]

Found picture of OEM V6 Low res crank sensor.

OEM V6 sensor.jpg

This is the 24x conversion sensor wheel

24x conversion.png

now if I can make it fit a V6 balancer.

here is the 24x sensor wheel to degrees.

LS1 24X Crank.jpg

[Dylan]

There's a model can't remember the name of V6 with the 0411 and it takes the 18X 3X crank and 1X cam. I'll see if I kept the link or maybe you're onto it all ready. Haven't followed the V6 to much so looked over it quickly.

[Apples]

I haven't seen a V6 using 18x 3x and 1x cam on a 411 from the factory.
that's not to say they don't exist.

[Dylan]

Fair chance I misread it. Would of been in the 1998 2002 era if it was.
Whats your plans anyway convert a V6 of yours to to the 0411? Once you have the trigger pattern sorted it's just like any other conversion.

[Apples]

well my plan is to try and run a V6 with ls1 coils and 411 pcm with auto.
then later on add 3 bar mafless tune.
I want to do it with out opening and modding the pcm.

[Dylan]

Sounds good keep us posted. Those low res trace pictures you posted. Do you have the whole manual for those models or just those images? Any chance you could PM a copy if you do?