OSE 12P V112

[VL400]

Yeah could very well be named from AC delco. All I know about the option is its for a different sensor type, the ACSP reference was in the original XDF/ECU files that have been around well before 12P so just named it the same.

[Apples]

I was thinking it was to select delphi / delco sensor so I could use VS sensor in my ecotec but I think I will use the bosch sensor that the 808 is programed for.

[syntaxterror]

I need advise on this set up. I am running a 7165 on a 3500 gm 60 degree v6 with dis ignition. I have searched but being from the US i am not familiar with holden engines. this is the trigger wheel I have on the engine which is stock for the 3500. I have run it on the 7730 but this code is so far ahead of that.
thanks
Joe

[VL400]

What advice/info are you after?

[syntaxterror]

Reference angle and other settings to get the dis to run right . I tried BLCD straight 6 bin and used these settings that worked on the 7730 Ref Angle to 60 , Max SA to -0.00 and Min SA to -69.97 but no luck . What would be a good starting bin ?

[Jayme]

what do you mean by no luck? no start? runs crap? more info please.

[syntaxterror]

Will not run fires but dies .

[festy]

Where does your CAS line up with the nearest notch in regards to TDC?

[Holden202T]

fires but dies, sounds like the reference angle is out to me, thats what i get when i test v6 tunes in the gemini

[syntaxterror]

Where does your CAS line up with the nearest notch in regards to TDC
What is a CAS ? This a stock set up so it lines at tdc. There is about 15* adjustment at the sensor.