Looking for a starter map, Kalmaker to $12P

Mr DOHC · Post by **Mr DOHC** » Thu Mar 11, 2021 4:53 am

I use KALMAKER SP3 N03 XDFVersion 1.xdf
And KALMAKER_SP3_N03 TP5.adx

VX L67 Getrag · Post by **VX L67 Getrag** » Fri Mar 12, 2021 12:02 am

I don't suppose you know what the changes are between 4C1 & 525 of the kalmaker file?
I'm pretty sure they're going to be some sort of EST or ESC but with that whole area being zero's it hard to tell where stuff starts & stops.

Mr DOHC · Post by **Mr DOHC** » Fri Mar 12, 2021 12:27 am

Sorry no, i don't even know what/where that refers to in the map.

VX L67 Getrag · Post by **VX L67 Getrag** » Fri Mar 12, 2021 1:26 am

This should be a good starting point, closest I can get with other items being unknown.

Mr DOHC · Post by **Mr DOHC** » Fri Mar 12, 2021 3:36 am

cools, when i get home i'll have a look

So i havent actually uploaded anything $12P to the Kalamker (but i have been able to run the Kalamker XDF and mod the current map). What do i need to do to actually upload it the first time?

VX L67 Getrag · Post by **VX L67 Getrag** » Fri Mar 12, 2021 11:42 am

Thanks for posting in open forum like I mentioned in PM along with advice...

It's only a starting point so once you get it on a memcal will need to log & adjust as need as kalmaker has cyl vol which OSE $12p doesn't so I had to fudge injector rate for your injectors & the cyl vol too so it could be slightly off... but lets see how well it goes!

Mr DOHC · Post by **Mr DOHC** » Sat Mar 13, 2021 2:28 am

Just having a look around the map and the Tip-in bump Spark seems to have a very random map. i dont even remember that in the Kalamker

is that a bad conversion from Kal to $12P?

Pic below

Post by **vlad01** » Sat Mar 13, 2021 2:37 am

I normally turn off RDSC which disables all the tip in bump stuff as it makes the engine rather unresponsive in my experience.

Never really looked at the tip in maps so can't tell you if it looks right or not.

VX L67 Getrag · Post by **VX L67 Getrag** » Sat Mar 13, 2021 4:12 am

That table is untouched... just how the $12p BLCF file is!

Mr DOHC · Post by **Mr DOHC** » Sat Mar 13, 2021 4:23 am

So what’s the map actually telling me?
Is it saying at 20% throttle at 1200rpm it’s going to knock 10.55 degrees of timing out?

Looking for a starter map, Kalmaker to $12P

Re: Looking for a starter map, Kalmaker to $12P

Re: Looking for a starter map, Kalmaker to $12P

Re: Looking for a starter map, Kalmaker to $12P

Re: Looking for a starter map, Kalmaker to $12P

Re: Looking for a starter map, Kalmaker to $12P

Re: Looking for a starter map, Kalmaker to $12P

Re: Looking for a starter map, Kalmaker to $12P

Re: Looking for a starter map, Kalmaker to $12P

Re: Looking for a starter map, Kalmaker to $12P

Re: Looking for a starter map, Kalmaker to $12P