hey guys
been having a problem with my auto trans lately..
4L60E with shift kit.
seems ok for about 15 mins of driving then starts playing games.
-revs out more into gear
-wont change into 4th even at 80k's
-when slowing down and take off again major delay into second - revs out
looked at dash status in tunerpro
quad driver 1 fault stays on or blinks on and off
quad driver 2 fault stays on
and cruise control is on?? (i removed the module) not needed atm
trans temp seems ok
dont go past 75c
also noticed manual mode input on the trans dash.. how do i supply the input for manual mode??
any help would be appreciated
i have a log if anyone has the time to help me
4L60E problems VR V8 turbo
-
turbov8
- Posts: 100
- Joined: Sun Oct 03, 2010 12:08 pm
- cars: VR SS TURBO AUTO
-
Holden202T
- Posts: 10435
- Joined: Sat Feb 28, 2009 11:05 am
- Location: Tenambit, NSW
Re: 4L60E problems VR V8 turbo
sounds like a screwed clutch or something, i assume you mean when it revs out, its flaring the revs before the gear engages ?
No matter what the question is, the answer is always more horsepower! 
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread

Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
-
turbov8
- Posts: 100
- Joined: Sun Oct 03, 2010 12:08 pm
- cars: VR SS TURBO AUTO
Re: 4L60E problems VR V8 turbo
yeah
gear changes at higher revs than normal and when it does finally change gear it slams
first to second higher revs than normal
second into third bit delayed
wont go into 4th at 80-90k's
went threw my tune again and changed all my trans stuff back to when i knew it was all working.
still have the quad faults green on at idle
quad driver one just flashes on and off
driver 2 is always on
gear changes at higher revs than normal and when it does finally change gear it slams
first to second higher revs than normal
second into third bit delayed
wont go into 4th at 80-90k's
went threw my tune again and changed all my trans stuff back to when i knew it was all working.
still have the quad faults green on at idle
quad driver one just flashes on and off
driver 2 is always on
-
Holden202T
- Posts: 10435
- Joined: Sat Feb 28, 2009 11:05 am
- Location: Tenambit, NSW
Re: 4L60E problems VR V8 turbo
so its still got the tranny issues with all the stock shift settings back in it ?
definately sounds like something hardware wise is not right.
definately sounds like something hardware wise is not right.
No matter what the question is, the answer is always more horsepower! 
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread

Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
-
turbov8
- Posts: 100
- Joined: Sun Oct 03, 2010 12:08 pm
- cars: VR SS TURBO AUTO
Re: 4L60E problems VR V8 turbo
changed trans back to stock settings and all is good so far.
few tables not right
will test more tomorrow
few tables not right
will test more tomorrow