253 V8 carby selection

['quipt4it]

.

[Madmatt2006]

You where right about bugger all shaft, I stuffed it right up!

20210619_105310.jpg

Have you seen the soap/grease method and a snug bolt for pushing the bushing back out? wonder if it works got any other ideas of getting it back out?

['quipt4it]

.

[Madmatt2006]

Ok I will give it a go fingers crossed. The original was removed with bolt forced threaded and keep screwing works great! takes under 2 minutes

['quipt4it]

.

[Madmatt2006]

The grease and bolt method works a treat just make sure the bolt is super snug fit and a normal hammer was shocked how easy

measured it also and will hook box back up and take more photo's

20210619_114620.jpg

20210619_114657.jpg

['quipt4it]

.

[Madmatt2006]

will do and hook box backup and take some pictures.

['quipt4it]

.

[Madmatt2006]

Just thinking over that bush again... is the chamfer the same on both ends?

No it's not but I put it in the same way as the old one, I think the chamfer is matched to the input shaft? shaped the same the flat end didn't seem right and it would make it hard to line the box up, but I'm no expert (obliviously)

Some more pictures

20210619_121719.jpg

20210619_122200.jpg

How is that looking? the tape is around the face of the shaft so only the piece that goes in is shown.