vt ss tuning questions?

[Doctor Bob]

as Yoda said most of the manual tunes have very little auto info in them, some have none at all
also it is normal to have different shift lines in cruise mode, they were calibrated that way at the factory
the kickdowns are normally different to avoid sudden burst of accel when it kicksdown.
Rob

[vnsswithcam]

yeah i kinda thought that i looked at the auto settings in the manual tune and they were different but i thought it might have been the setup for the hsv base tune im going to start again with a auto tune for sure.......
also ive heard that theres settings you can change to make the auto to manual shift when in power mode ? like if i push power mode and put into 1st gear it wont come out of 1st gear until i change it manually this set up would be for b&m quick shift setups?

[vnsswithcam]

hi guys,
ok im having a bit of trouble connecting my usb coms board to my car to data log? ive connected the coms board to a obd2 connector plugged it in to laptop and it powers up all ok downloaded driver all ok using ose plugin using vt v8 adx and using com port 3 as it says to but still no connection? ive tried all coms ports and unticked echo then tried it with echo ticked still nothing? is there something im missing here? im using a standard memcal that ive tuned lightly without data logging it and that tune is cjdn1927

[vnsswithcam]

ok ive managed to get it connected but i got engine light,airbag light coming on and the high speed fan is constantly on also all the dash values are all over the place??? am i using the wrong adx or would it be just a setting not ticked etc anyone else had this problem?

[yoda69]

Airbag, check engine and fans are normal when communication with the BCM is interrupted, so at least this command from the ADX is getting through.
If the dash gauges are all over the place it sounds like possibly an echo setting, or a data synch problem.

yoda69

[vnsswithcam]

so i cant stop the fan staying on and engine/airbag lights flashing when im data logging.... ok if thats normal no worries cheers for that.....ill have another play with it tomorrow and see if i can get the dash values to read normal
cheers

[vnsswithcam]

edit

[Jayme]

yeah i wouldnt be cruisin round in 4th under 70k's good way to wear out the overdrive prematurely.

[vnsswithcam]

should be fine theres a hsv tune that changes to 4th gear at 53km/h at 18.25% tps i think its CFZF ? gen 3's do to and they have the same auto transmission... i think it will be fine