custom remap to suite super6 ?

Post by **antus** » Thu Mar 03, 2011 7:30 pm

its worth noteing to run the factory supercharged tune not the normally aspirated as thats just as easy. hardware is the same (including the maf)

ethan9 · Post by **ethan9** » Thu Mar 03, 2011 7:31 pm

ohh alright, well i wouldnt mind just getting the computer changed over to manual and running the 10 psi pulley on the stock tune, its alot less hassel and will be a massive improvement over the stock vp engine anyway. any idea how much it would cost to get my computer ticked to manual ? and so your saying i can pull my entire loom out and replace it with the L67 loom and it will all work the same ? because as i have a calais i have the level 3 cluster setup like the statesman the engine is out of.

Post by **Jayme** » Thu Mar 03, 2011 7:42 pm

getting the engine to run is easy, there are just a few wires to manually hook up tho as I dont think it is a plug in job. interfacing to the dash is harder. to get the level3 cluster working I have a feeling youd need to put the bcm and dash out of whatever model car the engine came out of.
what model car is the engine from? VS, VT, VX? I can post you a memcal, $50 changeover.

ethan9 · Post by **ethan9** » Thu Mar 03, 2011 7:49 pm

i would of thought they would work as they are the same tho ? both clusters are level 3. i dont mind if my speedo and revs dont work, kinda need fuel and temp tho.
i will be pulling it from a vs statesman. and sounds like you have a deal with the computer

Post by **Jayme** » Thu Mar 03, 2011 8:05 pm

yeah I only mean the little digital screen at the bottom wont work. revs, speedo, fuel, temp, can be made to work fine.

ethan9 · Post by **ethan9** » Thu Mar 03, 2011 8:15 pm

okay so like the distance to empty and s### like that wont work ? thanks heaps for your help btw.

Post by **Jayme** » Thu Mar 03, 2011 9:12 pm

yeah the dist to empty wont work, im not an expert in this area, other members might want to correct me but I think that distance to empty screen works different from VP > VS. VP uses a signal wire with a square wave pulse whereas VS uses the aldl data.

ethan9 · Post by **ethan9** » Thu Mar 03, 2011 9:20 pm

ohwell that doesnt really bother me than just aslong as the basic's work. so i have an old vp computer sitting in my room the auto one from my car. could i send you that one and you map that to the manual l67 tune or does it have to be an l67 computer ?

Post by **VL400** » Thu Mar 03, 2011 9:23 pm

VS still uses a PWM signal for the trip computer but its got double the resolution. It should be just a matter of adjusting that in the VS L67 bin, have never tried it though.

ethan9 · Post by **ethan9** » Thu Mar 03, 2011 9:26 pm

vl400 is that so my whole dash will work you are refering to ??

custom remap to suite super6 ?

Re: custom remap to suite super6 ?

Re: custom remap to suite super6 ?

Re: custom remap to suite super6 ?

Re: custom remap to suite super6 ?

Re: custom remap to suite super6 ?

Re: custom remap to suite super6 ?

Re: custom remap to suite super6 ?

Re: custom remap to suite super6 ?

Re: custom remap to suite super6 ?

Re: custom remap to suite super6 ?