TunerPro Logging VX Flash pcm

[rileymax]

Hi all, trying to do some logging via tunerpro on my n/a v6 vx, using the1's adx with a envyous customs cable. For some reason in tunerpro, the data is really erratic, but if I use Envyous Customs Advanced engine diagnostics, it works perfectly fine. Any suggestions?

[yoda69]

May need to change the echo settings in the ADX.

[rileymax]

Cheers for the reply mate, yeah I've toggled the rs232 echo checkbox if that's what you're referring to
Other than that I'm not too sure what else to change

[rileymax]

Scratch that, tried again, checked the box again and changed stop bits from 1 to 2. Just didn't want to play with things I wasn't sure of but ah well, it's only a drift car

[antus]

stop bits 2 is definatltly not right. its the echo setting, this comes up often, your the second person in the last week. echo setting worked for the other guy too. Echo should be on. Leave stop bits standard at 1.

[rileymax]

Interesting, tried that about 4 different times, turned the car off, closed tunerpro, disconnected everything etc and nothing
I'll have to have another look later then I guess

[Rhysk94]

Sounds like the wrong adx is being used to me.
Had that happen when I had the wrong one open.

[rileymax]

Yeah I'm still not 100% on what's going on
If I hook the car up, and start logging straight away, it'll give me weird data, but if I load acquisition and choose the exact same ADX, about 3 out of 5 times it'll log correctly

It's not too much of an issue now that I've figured that out so I can live with it
Cheers for your help everyone

[4wheelinls1]

Same issue on a skid car, no BCM. Works as you said, start car load adx and start logging