Can someone confirm this, or I am only one with this problem?
If I set any application to listen CAN messages with VCX nano connected to E78 ecu, application crash after few seconds.
Tested so far:
Universalpatcher->Logger->Analyzer
J2534Tool (VX Manager->Diagnostic->Passthru->Run)
https://github.com/jakka351/J2534CANbusTool
I don't know where the problem is: E78, Vxdiag/passthru driver or my PC. So, testing with another ecu with CAN protocol may help, too.
btw. Vxdiag driver policy is horrible, can't recommend buying it - crash or not.
Vxdiag vcx nano crash with CAN ecu?
Vxdiag vcx nano crash with CAN ecu?
Last edited by joukoy on Mon Apr 07, 2025 2:05 pm, edited 1 time in total.
Re: Vxdiag vcx nano crash wit CAN ecu?
First step in troubleshooting anything that involves a vxdiag is throw it away and watch all your problems be solved 
