Vn turbo map sensor

[beeradoc]

Hi everyone,

I am in the process of building a turbo kit for my vn wagon.

Hoping for some input on the map sensor people have used?

I am hoping to retain stock ECU and memcal

[antus]

For up to 14.5 psi of boost, something like https://www.tiperformance.com.au/produc ... ap-sensor/ or for more go 3 bar. I havnt used this specific one but with clones on the market out there go for a brand that will support you if its DOA/Faulty or fake. Would recommend checking that up front with anyone and most the dodgy sellers will bail out and not respond or something. If they have confidence in their product and will stand by it you are probably ok. You should read about 103 kpa at key on no start, -40 to -50 give or take depending on your engine at idle and psi converted to kpa somewhat in line with your wastegate setup provided that works and no other hardware issues. Of course it'll overboost a little for a moment if it comes on hard and stay over if your waste gate is too small but thats all part of the build.

[Vrv8hz]

https://www.efisolutions.com.au/bosch-m ... WfEALw_wcB