E38 Documentation attempt - Starting from the DTC functions.

[Xnke]

25 downloads and no opinions?

Are they just bots digging?

[MPC001]

25 downloads and no opinions?

Are they just bots digging?

Had a quick look. Great progress. Most of the cals are under the parameter mem block folder (xdf def'd?). Some tables (lo/hi Oct spk (?) seem to have an area where the conv factor doesn't look right. What areas were you after feedback on specifically?

Will take another look.

[Tre-Cool]

i downloaded, havent had a chance to look yet.

[antus]

I've clicked it a couple of times and had a look. I have no goal and nothing to compare it too, so I appreciate the work and the share but nothing to add. Just watching to see what cool things people do with it.

[Xnke]

Nothing major, other than people actually were looking at it. If it was just bots digging it, I'd have pulled it down to save site bandwidth until the next update.

I am concerned that some of the tables are not defined correctly. I know the table area is correct, but the axes are not labeled right and the tables still look bad, they aren't being displayed in a format that looks "good" to me yet.

As far as I have worked it out so far, the fueling and engine displacement calculators in the tool menu only work for 9078, I am planning to make those tie in with the XDF, or find a way to auto recognize which BIN the tool is looking at, so that the calculator tools still work.

[KingAustraliaggGG]

I will have a look, I have a full e38 xdf for a few Holdena now. I even added the same ECM numbers that it's counterpart editor would use. Took alot of effort and was clean room

[KingAustraliaggGG]

I got xdf made for

E38 12609099 - my best one that has nothing missing.

P59 12592433 / 12587603

P01 12225074

E40 12598977