NVRAM file to sst39sf010a not working

EPROM EEPROM SRAM NVRAM Flash chips, reading/writing hardware and software
gasxp
Posts: 23
Joined: Mon Oct 04, 2021 11:35 am
cars: xp falcon

NVRAM file to sst39sf010a not working

Post by gasxp »

Hi all
Trying to write a bin file that i downloaded from the nvram to tuner pro and write it to a sst39sf010a using a gq4x4 burner.
I have followed all steps in the guide for using the burner and checking the files with HXD with no faults.
Put the chip in the car and get thermofan only. Tried 2 different chips with the same result
Please help
You do not have the required permissions to view the files attached to this post.
User avatar
delcowizzid
Posts: 5714
Joined: Sat Feb 28, 2009 10:38 am
Yahoo Messenger: [email protected]
Location: Wellington NZ

Re: NVRAM file to sst39sf010a not working

Post by delcowizzid »

You can't download the full bin via tunerpro software then burn it .read the nvram with it out of the board and then burn that read to the chip
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
User avatar
vlad01
Posts: 8600
Joined: Mon Oct 08, 2012 8:41 am
cars: VP I S
VP I executive
VP II executive
VP II executive #2
Location: Kyneton, Vic

Re: NVRAM file to sst39sf010a not working

Post by vlad01 »

You should be able to just use the OSE flash tool and use the get bin function. This gets the entire bin including the OS part. As delco said, TP only download the cal section and ignores the OS part of the bin. No OS, the PCM/ECU doesn't do anything, hence the limp mode and fan on key on. The OSE flash tool will save the hassle, pin breakage and corruption risks associated with physically removing the NVRAM chip.